Yukon pinion install kit for GM 8.5″ Oldsmobile rear

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Fits 8.5″ Oldsmobile with 28 spline axles

Fits 8.5″ Oldsmobile with 31 spline axles

Fits 8.5″ Oldsmobile with 31 spline axles